Seibertron.com Energon Pub Forums

by **UltraMaximus** » Sat May 10, 2014 9:34 pm

I had an Energon Rodimus figure missing his rear truck fins and just wondered if the Fans Project armor would fit on him.... What do you think?

News Credits: 668 · by **Autobot032** » Sun May 11, 2014 2:02 am

I personally feel that the vehicle mode is a bit too long. Visually, it looks like it should work and from certain angles, it does. I still think the Classics Rodimus mold works best with it. I see where you're going with this and it's an ambitious idea so far, I hope it works out!

by **UltraMaximus** » Sun May 11, 2014 1:02 pm

Autobot032 wrote:I personally feel that the vehicle mode is a bit too long. Visually, it looks like it should work and from certain angles, it does. I still think the Classics Rodimus mold works best with it. I see where you're going with this and it's an ambitious idea so far, I hope it works out!

I really just like the trailer on the truck, not sure how to get it to fit better. Tempted to get another one to set it up and just have it turn into the cannon transformed. I just think this looks damned cool.